# status of various device drivers on a B180L+ # disk controllers ahc works if we avoid PCI IO space esiop works isp works adw passes autoconf, not tested bha passes autoconf, not tested (for some chips, firmware doesn't start) BT-948 is good twe passes autoconf, not tested (ATA) hptide passes autoconf, not tested (ATA) pcscp passes autoconf, not tested aac "aac0: FATAL: selftest failed" (just like on x86) ahd hangs during autoconf adv "adv_init: failed to find signature" amr hangs during autoconf cac "cac0: can't map i/o or memory space" "cac0: CAC_CMD_GET_CTRL_INFO failed" dpt "dpt0: EATA signature mismatch" iha hangs during autoconf (just like on x86) mpt "mpt0: mpt_recv_handshake_cmd timeout3" trm hangs during autoconf icp firmware doesn't start iop firmware doesn't start mlx firmware doesn't start mly firmware doesn't start # network interfaces epic works - REALLY bad performance fxp works ne works pcn works - bad performance rtk0 works sip works tlp works sk passes autoconf, not tested (fibre) bge "panic: mbus_dmamap_sync: bad length" can xmit but not recv macppc fails the same way - driver is probably broken for big-endian ex hangs during autoconf fpa "fpa0: initialization failed" gsip passes autoconf, ping ok, ttcp causes weird problems re "You may have a defective 32-bit NIC plugged into a 64-bit PCI slot." sf xmit ok, recv mangles packets stge passes autoconf, "stge0: device timeout" "stge0: DMA wait timed out" ti "ti0: unsupported chip revision 0x30000000" -- card works on x86 tl hangs during autoconf wm passes autoconf, ping ok, ttcp has lots of input errors hme firmware starts but cannot load boot image txp firmware doesn't start vge firmware doesn't start # USB nec firmware doesn't start via works ali works umass works url works axe no xmit, no recv kue "panic: unaligned data ref trap"